The pull cylinder (double-acting pull hydraulic jack) customized for the customer this time has passed the factory test and is ready to be packaged and sent to the customer. According to customer requirements, our customized long stroke cylinder adopts low pressure 13MPa to meet the customer's need to complete 1 meter3 stroke.

The following is a picture of the custom cylinder we will be issuing this time.

Thrust: 13 tons 　　

Pressure: 13MPa 　　

Stroke: 1300mm

Thrust: 5.5 tons 　　

Stroke 80mm 　　

Working pressure: 70MPa

Hydraulic cylinder composition:

Hydraulic cylinder (hydraulic jack) is mainly composed of cylinder barrel and cylinder head, piston and piston rod, and sealing device. Under special circumstances, buffer devices and exhaust devices can be added.

　　According to the piston rod reduction method, it can be divided into single action and double action.

　　According to the structural form, it can be divided into piston type, plunger type, multi-stage telescopic sleeve type, rack and pinion type, etc.

　　According to the installation form, it can be divided into tie rods, earrings, feet, hinges, etc.

　　The cylinder block and piston rod are made of high-strength special steel and nickel-plated on the surface, which is strong and wear-resistant.

　　Over the years, Jiangsu Kent has continuously surpassed itself in the field of cylinder production through technological innovation, continuously improved the quality control link, and achieved new development in management innovation, cultural innovation and thinking innovation.

　　Jiangsu Kent - hydraulic jack manufacturer, you can trust, welcome to call: 0523-86186888